It is never pleasant to listen to a noise from your car you don’t know where from. So what if you notice a serpentine belt noise that remains on your Renault Clio 2 Campus? It is extremely conceivable that this is a insignificant trouble, but before being sure, it is better to operate some checks. If this belt noise comes from your serpentine or driving belt, our team has written a content to help you locating and solving it. First, we will look at the serpentine belt noises on your Renault Clio 2 Campus and then we will check out the origins of these sounds.
I feel noises from serpentine belt Renault Clio 2 Campus
The best method to control the state of your belts is to listen to your vehicle. Immediately after you recognise sounds such as squealing or bells, you should take a closer look to examine their source. The task of the serpentine belt or driving belt of your Renault Clio 2 Campus is to transmit the movement of the engine to the secondary elements that it will supply with energy. Like steering, air conditioning, water pump. Its role is therefore important in the normal use of your vehicle. The serpentine belt is said to be asynchronous, i.e. unlike the timing belt, it has the capacity to drive different engine elements at variable speeds.
I listen to squealing noises on my serpentine belt Renault Clio 2 Campus
This type of squealing belt noises on Renault Clio 2 Campus, which will often be acute, can generally occur when the engine is cold, or when the acceleration increases in intensity. . This type of noise must be heavy and it is often quite simple to connect it with one of these belts. To examine, do not hesitate to open your bonnet, engine running cold and check the source of this noise, the serpentine or driving belt being exposed, it should not be too difficult for you to point a belt noise on your Renault Clio 2 Campus. The cause of this trouble can be in connection with the damper pulley, which operates as a damper to eradicate irregularities in the tension in the motor cycle and therefore in the energy transmission to the belt. This results in a loose belt that will jerk. However, you still have an opportunity that this event is annodine. As the serpentine belt of your Renault Clio 2 Campus is exposed, it may squeak due to excessive humidity due to weather conditions and it may stop with a change in conditions. Remember to examine the state of your belt (crack, crack), if this is the case swap it, otherwise simply tighten the belt.
I listen to loud serpentine or driving belt noises Renault Clio 2 Campus
Just like squealing, a driving belt noise on your Renault Clio 2 Campus that sounds like a loud grinding sound can reveal a lot about its state. It is therefore essential that you look further and locate the cause for this sound that can signal the end of your belt’s life. Like squealing noise, it can be identified in most cases when cold . It generally means a worn pulley whose streaks no longer allow it to be driven correctly. Other alternatives, the dynamic belt tensioner or the disengageable pulley of the alternator may be at the source of this trouble. Make sure to examine first the serpentine/driving belt which in most cases is the cause of this trouble, otherwise it will be necessary to swap the tensioner or pulley.
I listen to bearing noises on the serpentine belt of my Renault Clio 2 Campus
Finally, if in your case you recognize a bearing belt noise on Renault Clio 2 Campus, it is conceivable that it is in connection with a serpentine belt that is too tight . Indeed, it is conceivable that its size may be smaller than recommended and cause the entire system to overvoltage, resulting in this whistling noise or slight rolling noise. The problem in this case is that the bearing bearings or the Damper pulley may fail . Remember, therefore, to stretch the belt to limit the risks or to change it if it is too short. If after checking all thoses alternatives, you still perceive a belt noises, read our article about timing belt noises on Renault Clio 2 Campus which could maybe help you.
