It is never pleasant to perceive a noise from your car you don’t know where from. Then what if you detect a serpentine belt noise that persists on your Peugeot Partner 2? It is very conceivable that this is a minimal problem, but before being sure, it is better to carry out some inspections. If this belt noise comes from your serpentine or driving belt, our team has written a content to support you locating and solving it. First, we will look at the serpentine belt noises on your Peugeot Partner 2 and then we will take a look at the origins of these noises.
I encounter noises from serpentine belt Peugeot Partner 2
The best strategy to check the state of your belts is to listen to your automobile. Immediately after you recognize noises such as squealing or bells, you should take a closer look to verify their origin. The job of the serpentine belt or driving belt of your Peugeot Partner 2 is to transmit the movement of the engine to the secondary elements that it will supply with energy. Like steering, air conditioning, water pump. Its role is therefore vital in the normal general performance of your automobile. The serpentine belt is said to be asynchronous, i.e. unlike the timing belt, it has the ability to drive distinctive engine elements at variable speeds.
I perceive squealing noises on my serpentine belt Peugeot Partner 2
This sort of squealing belt noises on Peugeot Partner 2, which will often be acute, can commonly happen when the engine is cold, or when the acceleration increases in intensity. . This sort of noise must be significant and it is obviously quite simple to link it with one of these belts. To verify, do not hesitate to open your bonnet, engine running cold and check the origin of this noise, the serpentine or driving belt being exposed, it should not be too difficult for you to locate a belt noise on your Peugeot Partner 2. The cause of this problem can be linked to the damper pulley, which acts as a damper to eradicate irregularities in the tension in the motor cycle and therefore in the energy transmission to the belt. This results in a loose belt that will jerk. However, you still have a chance that this event is annodine. As the serpentine belt of your Peugeot Partner 2 is exposed, it may squeak due to excessive humidity due to weather conditions and it may end with a change in conditions. Keep in mind to verify the state of your belt (crack, crack), if this is the case change it, otherwise simply tighten the belt.
I perceive loud serpentine or driving belt noises Peugeot Partner 2
Just like squealing, a driving belt noise on your Peugeot Partner 2 that sounds like a loud grinding sound can express a lot about its state. It is therefore imperative that you look further and find the reason for this sound that can signal the end of your belt’s life. Like squealing noise, it can be identified in most cases when cold . It generally means a worn pulley whose streaks no longer allow it to be driven properly. Other possibilities, the dynamic belt tensioner or the disengageable pulley of the alternator may be at the origin of this problem. Make sure you verify first the serpentine/driving belt which in most cases is the cause of this problem, otherwise it will be necessary to change the tensioner or pulley.
I perceive bearing noises on the serpentine belt of my Peugeot Partner 2
Finally, if in your case you distinguish a bearing belt noise on Peugeot Partner 2, it is conceivable that it is linked to a serpentine belt that is too tight . Indeed, it is conceivable that its size may be smaller than prescribed and cause the entire system to overvoltage, resulting in this whistling noise or slight rolling noise. The problem in this case is that the bearing bearings or the Damper pulley may fail . Remember, therefore, to stretch the belt to limit the risks or to swap it if it is too short. If after checking all thoses possibilities, you still perceive a belt noises, read our article about timing belt noises on Peugeot Partner 2 which could maybe help you.
