It is never pleasant to listen to a noise from your car you don’t know where from. Thus what if you locate a serpentine belt noise that lasts on your Mitsubishi Outlander? It is highly plausible that this is a minor trouble, but before being sure, it is better to carry out some verifications. If this belt noise comes from your serpentine or driving belt, our team has written a post to support you finding and solving it. First, we will look at the serpentine belt noises on your Mitsubishi Outlander and then we will take a look at the sources of these sounds.
I experience noises from serpentine belt Mitsubishi Outlander
The best method to check the state of your belts is to listen to your vehicle. Immediately after you perceive sounds such as squealing or bells, you should take a closer look to verify their source. The role of the serpentine belt or driving belt of your Mitsubishi Outlander is to transmit the movement of the engine to the secondary elements that it will supply with energy. Like steering, air conditioning, water pump. Its role is therefore essential in the normal overall performance of your vehicle. The serpentine belt is said to be asynchronous, i.e. unlike the timing belt, it has the capacity to drive distinctive engine elements at variable speeds.
I listen to squealing noises on my serpentine belt Mitsubishi Outlander
This kind of squealing belt noises on Mitsubishi Outlander, which will often be acute, can commonly arise when the engine is cold, or when the acceleration increases in intensity. . This kind of noise must be significant and it is obviously quite simple to link it with one of these belts. To verify, do not hesitate to open your bonnet, engine running cold and check the source of this noise, the serpentine or driving belt being exposed, it should not be too complicated for you to identify a belt noise on your Mitsubishi Outlander. The cause of this trouble can be connected to the damper pulley, which acts as a damper to get rid of irregularities in the tension in the motor cycle and therefore in the energy transmission to the belt. This results in a loose belt that will jerk. However, you still have the opportunity that this phenomenon is annodine. As the serpentine belt of your Mitsubishi Outlander is exposed, it may squeak due to excessive humidity due to weather conditions and it may stop with a change in conditions. Keep in mind to verify the state of your belt (crack, crack), if this is the case swap it, otherwise simply tighten the belt.
I listen to loud serpentine or driving belt noises Mitsubishi Outlander
Just like squealing, a driving belt noise on your Mitsubishi Outlander that sounds like a loud grinding sound can say a lot about its state. It is therefore essential that you look further and locate the cause for this sound that can indicate the end of your belt’s life. Like squealing noise, it can be identified in most cases when cold . It generally means a worn pulley whose streaks no longer allow it to be driven correctly. Other possibilities, the dynamic belt tensioner or the disengageable pulley of the alternator may be at the source of this trouble. Make sure to verify first the serpentine/driving belt which in most cases is the cause of this trouble, otherwise it will be necessary to swap the tensioner or pulley.
I listen to bearing noises on the serpentine belt of my Mitsubishi Outlander
Finally, if in your case you distinguish a bearing belt noise on Mitsubishi Outlander, it is plausible that it is connected to a serpentine belt that is too tight . Indeed, it is plausible that its size may be smaller than prescribed and cause the entire system to overvoltage, resulting in this whistling noise or slight rolling noise. The risk in this case is that the bearing bearings or the Damper pulley may fail . Remember, therefore, to stretch the belt to limit the risks or to swap it if it is too short. If after checking all thoses possibilities, you still notice a belt noises, read our article about timing belt noises on Mitsubishi Outlander which could maybe help you.
