It is never pleasant to listen to a noise from your car you don’t know where from. So what if you discover a serpentine belt noise that lasts on your Mitsubishi Mirage? It is extremely conceivable that this is a insignificant problem, but before being sure, it is better to execute some investigations. If this belt noise comes from your serpentine or driving belt, our team has written a page to help you locating and fixing it. First, we will look at the serpentine belt noises on your Mitsubishi Mirage and then we will look at the sources of these sounds.
I experience noises from serpentine belt Mitsubishi Mirage
The best technique to control the condition of your belts is to listen to your vehicle. As soon as you find sounds such as squealing or bells, you should take a closer look to verify their origin. The role of the serpentine belt or driving belt of your Mitsubishi Mirage is to transmit the movement of the engine to the secondary parts that it will supply with energy. Like steering, air conditioning, water pump. Its role is therefore important in the normal general performance of your vehicle. The serpentine belt is said to be asynchronous, i.e. unlike the timing belt, it has the ability to drive distinctive engine parts at variable speeds.
I listen to squealing noises on my serpentine belt Mitsubishi Mirage
This sort of squealing belt noises on Mitsubishi Mirage, which will often be acute, can commonly happen when the engine is cold, or when the acceleration increases in intensity. . This sort of noise must be significant and it is obviously quite simple to relate it with one of these belts. To verify, do not hesitate to open your bonnet, engine running cold and check the origin of this noise, the serpentine or driving belt being apparent, it should not be too difficult for you to spot a belt noise on your Mitsubishi Mirage. The reason of this problem can be related to the damper pulley, which functions as a damper to eliminate irregularities in the tension in the motor cycle and therefore in the energy transmission to the belt. This results in a loose belt that will jerk. However, you still have the possibility that this phenomenon is annodine. As the serpentine belt of your Mitsubishi Mirage is exposed, it may squeak due to excessive humidity due to weather conditions and it may end with a change in conditions. Keep in mind to verify the condition of your belt (crack, crack), if this is the case swap it, otherwise simply tighten the belt.
I listen to loud serpentine or driving belt noises Mitsubishi Mirage
Just like squealing, a driving belt noise on your Mitsubishi Mirage that sounds like a loud grinding sound can say a lot about its condition. It is therefore essential that you look further and locate the cause for this sound that can signal the end of your belt’s life. Like squealing noise, it can be identified in most cases when cold . It generally means a worn pulley whose streaks no longer allow it to be driven properly. Other possibilities, the dynamic belt tensioner or the disengageable pulley of the alternator may be at the origin of this problem. Make sure you verify first the serpentine/driving belt which in most cases is the reason of this problem, otherwise it will be necessary to swap the tensioner or pulley.
I listen to bearing noises on the serpentine belt of my Mitsubishi Mirage
Finally, if in your case you recognize a bearing belt noise on Mitsubishi Mirage, it is conceivable that it is related to a serpentine belt that is too tight . Indeed, it is conceivable that its size may be smaller than suggested and cause the entire system to overvoltage, resulting in this whistling noise or slight rolling noise. The problem in this case is that the bearing bearings or the Damper pulley may fail . Remember, therefore, to stretch the belt to limit the risks or to swap it if it is too short. If after checking all thoses possibilities, you still perceive a belt noises, read our article about timing belt noises on Mitsubishi Mirage which could maybe help you.
