It is never pleasurable to discover a noise from your car you don’t know where from. Thus what if you identify a serpentine belt noise that stays on your Mitsubishi Asx? It is very conceivable that this is a minimal problem, but before being sure, it is better to execute some inspections. If this belt noise comes from your serpentine or driving belt, our team has written a post to help you locating and repairing it. First, we will look at the serpentine belt noises on your Mitsubishi Asx and then we will look at the sources of these noises.
I encounter noises from serpentine belt Mitsubishi Asx
The best technique to control the state of your belts is to listen to your vehicle. Immediately after you find noises such as squealing or bells, you should take a closer look to examine their origin. The function of the serpentine belt or driving belt of your Mitsubishi Asx is to transmit the movement of the engine to the secondary parts that it will supply with energy. Like steering, air conditioning, water pump. Its role is therefore fundamental in the normal operation of your vehicle. The serpentine belt is said to be asynchronous, i.e. unlike the timing belt, it has the ability to drive distinctive engine parts at variable speeds.
I discover squealing noises on my serpentine belt Mitsubishi Asx
This type of squealing belt noises on Mitsubishi Asx, which will often be acute, can generally appear when the engine is cold, or when the acceleration increases in intensity. . This type of sound must be significant and it is often quite simple to relate it with one of these belts. To examine, do not hesitate to open your bonnet, engine running cold and check the origin of this noise, the serpentine or driving belt being accessible, it should not be too complicated for you to locate a belt noise on your Mitsubishi Asx. The cause of this problem can be linked to the damper pulley, which acts as a damper to reduce irregularities in the tension in the motor cycle and therefore in the energy transmission to the belt. This results in a loose belt that will jerk. However, you still have a chance that this phenomenon is annodine. As the serpentine belt of your Mitsubishi Asx is exposed, it may squeak due to excessive humidity due to weather conditions and it may end with a change in conditions. Keep in mind to examine the state of your belt (crack, crack), if this is the case replace it, otherwise simply tighten the belt.
I discover loud serpentine or driving belt noises Mitsubishi Asx
Just like squealing, a driving belt noise on your Mitsubishi Asx that sounds like a loud grinding sound can say a lot about its state. It is therefore imperative that you look further and locate the cause for this sound that can indicate the end of your belt’s life. Like squealing noise, it can be identified in most cases when cold . It generally means a worn pulley whose streaks no longer allow it to be driven properly. Other possibilities, the dynamic belt tensioner or the disengageable pulley of the alternator may be at the origin of this problem. Make sure to examine first the serpentine/driving belt which in most cases is the cause of this problem, otherwise it will be necessary to replace the tensioner or pulley.
I discover bearing noises on the serpentine belt of my Mitsubishi Asx
Finally, if in your case you recognize a bearing belt noise on Mitsubishi Asx, it is conceivable that it is linked to a serpentine belt that is too tight . Indeed, it is conceivable that its size may be smaller than recommended and cause the entire system to overvoltage, resulting in this whistling noise or slight rolling noise. The problem in this case is that the bearing bearings or the Damper pulley may fail . Remember, therefore, to stretch the belt to limit the risks or to change it if it is too short. If after checking all thoses possibilities, you still perceive a belt noises, read our article about timing belt noises on Mitsubishi Asx which could maybe help you.
