It is never pleasurable to discover a noise from your car you don’t know where from. Thus what if you detect a serpentine belt noise that stays on your Mazda Mx5? It is extremely conceivable that this is a unimportant issue, but before being sure, it is better to operate some inspections. If this belt noise comes from your serpentine or driving belt, our team has written an article to support you locating and correcting it. First, we will look at the serpentine belt noises on your Mazda Mx5 and then we will look at the sources of these noises.serpentine-belt-noise-mazda-mx5

I encounter noises from serpentine belt Mazda Mx5

The best strategy to control the state of your belts is to listen to your car. Immediately after you recognise noises such as squealing or bells, you should take a closer look to examine their source. The role of the serpentine belt or driving belt of your Mazda Mx5 is to transmit the movement of the engine to the secondary parts that it will supply with energy. Like steering, air conditioning, water pump. Its role is therefore important in the normal use of your car. The serpentine belt is said to be asynchronous, i.e. unlike the timing belt, it has the capacity to drive distinctive engine parts at variable speeds.

I discover squealing noises on my serpentine belt Mazda Mx5

This type of squealing belt noises on Mazda Mx5, which will often be acute, can commonly appear when the engine is cold, or when the acceleration increases in intensity. . This type of noise must be significant and it is normally quite simple to link it with one of these belts. To examine, do not hesitate to open your bonnet, engine running cold and check the source of this noise, the serpentine or driving belt being visible, it should not be too complicated for you to identify a belt noise on your Mazda Mx5. The cause of this issue can be connected to the damper pulley, which acts as a damper to get rid of irregularities in the tension in the motor cycle and therefore in the energy transmission to the belt. This results in a loose belt that will jerk. However, you still have the opportunity that this event is annodine. As the serpentine belt of your Mazda Mx5 is exposed, it may squeak due to excessive humidity due to weather conditions and it may end with a change in conditions. Keep in mind to examine the state of your belt (crack, crack), if this is the case swap it, otherwise simply tighten the belt.

I discover loud serpentine or driving belt noises Mazda Mx5

Just like squealing, a driving belt noise on your Mazda Mx5 that sounds like a loud grinding sound can reveal a lot about its state. It is therefore important that you look further and locate the cause for this sound that can signal the end of your belt’s life. Like squealing noise, it can be identified in most cases when cold . It generally means a worn pulley whose streaks no longer allow it to be driven properly. Other alternatives, the dynamic belt tensioner or the disengageable pulley of the alternator may be at the source of this issue. Don’t forget to examine first the serpentine/driving belt which in most cases is the cause of this issue, otherwise it will be necessary to swap the tensioner or pulley.

I discover bearing noises on the serpentine belt of my Mazda Mx5

Finally, if in your case you discern a bearing belt noise on Mazda Mx5, it is conceivable that it is connected to a serpentine belt that is too tight . Indeed, it is conceivable that its size may be smaller than prescribed and cause the entire system to overvoltage, resulting in this whistling noise or slight rolling noise. The risk in this case is that the bearing bearings or the Damper pulley may fail . Remember, therefore, to stretch the belt to limit the risks or to swap it if it is too short. If after checking all thoses alternatives, you still notice a belt noises, read our article about timing belt noises on Mazda Mx5 which could maybe help you.