It is never relaxing to perceive a noise from your car you don’t know where from. Then what if you detect a serpentine belt noise that lasts on your Hyundai Ix20? It is very plausible that this is a minor problem, but before being sure, it is better to conduct some investigations. If this belt noise comes from your serpentine or driving belt, our team has written a post to help you locating and correcting it. First, we will look at the serpentine belt noises on your Hyundai Ix20 and then we will take a look at the origins of these noises.
I encounter noises from serpentine belt Hyundai Ix20
The best strategy to check the state of your belts is to listen to your vehicle. Immediately after you perceive noises such as squealing or bells, you should take a closer look to check their origin. The job of the serpentine belt or driving belt of your Hyundai Ix20 is to transfer the movement of the engine to the secondary parts that it will supply with energy. Like steering, air conditioning, water pump. Its role is therefore fundamental in the normal functionality of your vehicle. The serpentine belt is said to be asynchronous, i.e. unlike the timing belt, it has the capacity to drive different engine parts at variable speeds.
I perceive squealing noises on my serpentine belt Hyundai Ix20
This sort of squealing belt noises on Hyundai Ix20, which will often be acute, can generally happen when the engine is cold, or when the acceleration increases in intensity. . This sort of sound must be heavy and it is obviously quite simple to connect it with one of these belts. To check, do not hesitate to open your bonnet, engine running cold and check the origin of this noise, the serpentine or driving belt being accessible, it should not be too complicated for you to spot a belt noise on your Hyundai Ix20. The cause of this problem can be related to the damper pulley, which acts as a damper to get rid of irregularities in the tension in the motor cycle and therefore in the energy transmission to the belt. This results in a loose belt that will jerk. However, you still have the opportunity that this phenomenon is annodine. As the serpentine belt of your Hyundai Ix20 is exposed, it may squeak due to excessive humidity due to weather conditions and it may stop with a change in conditions. Keep in mind to check the state of your belt (crack, crack), if this is the case change it, otherwise simply tighten the belt.
I perceive loud serpentine or driving belt noises Hyundai Ix20
Just like squealing, a driving belt noise on your Hyundai Ix20 that sounds like a loud grinding sound can say a lot about its state. It is therefore essential that you look further and locate the reason for this sound that can signal the end of your belt’s life. Like squealing noise, it can be identified in most cases when cold . It generally means a worn pulley whose streaks no longer allow it to be driven correctly. Other alternatives, the dynamic belt tensioner or the disengageable pulley of the alternator may be at the origin of this problem. Remember to check first the serpentine/driving belt which in most cases is the cause of this problem, otherwise it will be necessary to change the tensioner or pulley.
I perceive bearing noises on the serpentine belt of my Hyundai Ix20
Finally, if in your case you distinguish a bearing belt noise on Hyundai Ix20, it is plausible that it is related to a serpentine belt that is too tight . Indeed, it is plausible that its size may be smaller than prescribed and cause the entire system to overvoltage, resulting in this whistling noise or slight rolling noise. The problem in this case is that the bearing bearings or the Damper pulley may fail . Remember, therefore, to stretch the belt to limit the risks or to replace it if it is too short. If after checking all thoses alternatives, you still identify a belt noises, read our article about timing belt noises on Hyundai Ix20 which could maybe help you.
