It is never relaxing to listen to a noise from your car you don’t know where from. Then what if you discover a serpentine belt noise that lasts on your hyundai i10? It is very plausible that this is a minimal issue, but before being sure, it is better to carry out some verifications. If this belt noise comes from your serpentine or driving belt, our team has written a document to help you finding and correcting it. First, we will look at the serpentine belt noises on your hyundai i10 and then we will check out the sources of these sounds.
I experience noises from serpentine belt hyundai i10
The best way to control the condition of your belts is to listen to your automobile. As soon as you notice sounds such as squealing or bells, you should take a closer look to check their source. The function of the serpentine belt or driving belt of your hyundai i10 is to transfer the movement of the engine to the secondary parts that it will supply with energy. Like steering, air conditioning, water pump. Its role is therefore fundamental in the normal use of your automobile. The serpentine belt is said to be asynchronous, i.e. unlike the timing belt, it has the ability to drive distinctive engine parts at variable speeds.
I listen to squealing noises on my serpentine belt hyundai i10
This type of squealing belt noises on hyundai i10, which will often be acute, can generally happen when the engine is cold, or when the acceleration increases in intensity. . This type of noise must be significant and it is often quite simple to connect it with one of these belts. To check, do not hesitate to open your bonnet, engine running cold and check the source of this noise, the serpentine or driving belt being exposed, it should not be too complicated for you to locate a belt noise on your hyundai i10. The cause of this issue can be connected to the damper pulley, which acts as a damper to eliminate irregularities in the tension in the motor cycle and therefore in the energy transmission to the belt. This results in a loose belt that will jerk. However, you still have a chance that this phenomenon is annodine. As the serpentine belt of your hyundai i10 is exposed, it may squeak due to excessive humidity due to weather conditions and it may stop with a change in conditions. Keep in mind to check the condition of your belt (crack, crack), if this is the case replace it, otherwise simply tighten the belt.
I listen to loud serpentine or driving belt noises hyundai i10
Just like squealing, a driving belt noise on your hyundai i10 that sounds like a loud grinding sound can say a lot about its condition. It is therefore essential that you look further and find the reason for this sound that can signal the end of your belt’s life. Like squealing noise, it can be identified in most cases when cold . It generally means a worn pulley whose streaks no longer allow it to be driven properly. Other alternatives, the dynamic belt tensioner or the disengageable pulley of the alternator may be at the source of this issue. Make sure to check first the serpentine/driving belt which in most cases is the cause of this issue, otherwise it will be necessary to replace the tensioner or pulley.
I listen to bearing noises on the serpentine belt of my hyundai i10
Finally, if in your case you distinguish a bearing belt noise on hyundai i10, it is plausible that it is connected to a serpentine belt that is too tight . Indeed, it is plausible that its size may be smaller than prescribed and cause the entire system to overvoltage, resulting in this whistling noise or slight rolling noise. The problem in this case is that the bearing bearings or the Damper pulley may fail . Remember, therefore, to stretch the belt to limit the risks or to swap it if it is too short. If after checking all thoses alternatives, you still detect a belt noises, read our article about timing belt noises on hyundai i10 which could maybe help you.
