It is never enjoyable to discover a noise from your car you don’t know where from. So what if you notice a serpentine belt noise that stays on your Hyundai Elantra? It is very possible that this is a minimal problem, but before being sure, it is better to execute some investigations. If this belt noise comes from your serpentine or driving belt, our team has written a content to support you locating and solving it. First, we will look at the serpentine belt noises on your Hyundai Elantra and then we will check out the origins of these noises.
I experience noises from serpentine belt Hyundai Elantra
The best way to check the condition of your belts is to listen to your automobile. As soon as you detect noises such as squealing or bells, you should take a closer look to check their source. The task of the serpentine belt or driving belt of your Hyundai Elantra is to transmit the movement of the engine to the secondary parts that it will supply with energy. Like steering, air conditioning, water pump. Its role is therefore fundamental in the normal overall performance of your automobile. The serpentine belt is said to be asynchronous, i.e. unlike the timing belt, it has the ability to drive distinctive engine parts at variable speeds.
I discover squealing noises on my serpentine belt Hyundai Elantra
This type of squealing belt noises on Hyundai Elantra, which will often be acute, can mostly occur when the engine is cold, or when the acceleration increases in intensity. . This type of sound must be heavy and it is normally quite simple to relate it with one of these belts. To check, do not hesitate to open your bonnet, engine running cold and check the source of this noise, the serpentine or driving belt being apparent, it should not be too complicated for you to identify a belt noise on your Hyundai Elantra. The reason of this problem can be in connection with the damper pulley, which acts as a damper to get rid of irregularities in the tension in the motor cycle and therefore in the energy transmission to the belt. This results in a loose belt that will jerk. However, you still have an opportunity that this event is annodine. As the serpentine belt of your Hyundai Elantra is exposed, it may squeak due to excessive humidity due to weather conditions and it may stop with a change in conditions. Remember to check the condition of your belt (crack, crack), if this is the case change it, otherwise simply tighten the belt.
I discover loud serpentine or driving belt noises Hyundai Elantra
Just like squealing, a driving belt noise on your Hyundai Elantra that sounds like a loud grinding sound can tell you a lot about its condition. It is therefore important that you look further and locate the reason for this sound that can signal the end of your belt’s life. Like squealing noise, it can be identified in most cases when cold . It generally means a worn pulley whose streaks no longer allow it to be driven properly. Other alternatives, the dynamic belt tensioner or the disengageable pulley of the alternator may be at the source of this problem. Don’t forget to check first the serpentine/driving belt which in most cases is the reason of this problem, otherwise it will be necessary to change the tensioner or pulley.
I discover bearing noises on the serpentine belt of my Hyundai Elantra
Finally, if in your case you distinguish a bearing belt noise on Hyundai Elantra, it is possible that it is in connection with a serpentine belt that is too tight . Indeed, it is possible that its size may be smaller than recommended and cause the entire system to overvoltage, resulting in this whistling noise or slight rolling noise. The risk in this case is that the bearing bearings or the Damper pulley may fail . Remember, therefore, to stretch the belt to limit the risks or to replace it if it is too short. If after checking all thoses alternatives, you still identify a belt noises, read our article about timing belt noises on Hyundai Elantra which could maybe help you.
