It is never enjoyable to notice a noise from your car you don’t know where from. Thus what if you notice a serpentine belt noise that lasts on your Ford S-max 2? It is highly possible that this is a insignificant issue, but before being sure, it is better to operate some inspections. If this belt noise comes from your serpentine or driving belt, our team has written a post to help you finding and correcting it. First, we will look at the serpentine belt noises on your Ford S-max 2 and then we will check out the origins of these sounds.
I encounter noises from serpentine belt Ford S-max 2
The best way to control the state of your belts is to listen to your vehicle. Immediately after you recognise sounds such as squealing or bells, you should take a closer look to verify their source. The job of the serpentine belt or driving belt of your Ford S-max 2 is to transfer the movement of the engine to the secondary parts that it will supply with energy. Like steering, air conditioning, water pump. Its role is therefore vital in the normal operation of your vehicle. The serpentine belt is said to be asynchronous, i.e. unlike the timing belt, it has the ability to drive different engine parts at variable speeds.
I notice squealing noises on my serpentine belt Ford S-max 2
This type of squealing belt noises on Ford S-max 2, which will often be acute, can commonly happen when the engine is cold, or when the acceleration increases in intensity. . This type of sound must be heavy and it is often quite simple to associate it with one of these belts. To verify, do not hesitate to open your bonnet, engine running cold and check the source of this noise, the serpentine or driving belt being apparent, it should not be too complicated for you to point a belt noise on your Ford S-max 2. The cause of this issue can be connected to the damper pulley, which operates as a damper to eradicate irregularities in the tension in the motor cycle and therefore in the energy transmission to the belt. This results in a loose belt that will jerk. However, you still have an opportunity that this event is annodine. As the serpentine belt of your Ford S-max 2 is exposed, it may squeak due to excessive humidity due to weather conditions and it may end with a change in conditions. Keep in mind to verify the state of your belt (crack, crack), if this is the case replace it, otherwise simply tighten the belt.
I notice loud serpentine or driving belt noises Ford S-max 2
Just like squealing, a driving belt noise on your Ford S-max 2 that sounds like a loud grinding sound can tell you a lot about its state. It is therefore necessary that you look further and find the reason for this sound that can signal the end of your belt’s life. Like squealing noise, it can be identified in most cases when cold . It generally means a worn pulley whose streaks no longer allow it to be driven correctly. Other alternatives, the dynamic belt tensioner or the disengageable pulley of the alternator may be at the source of this issue. Make sure to verify first the serpentine/driving belt which in most cases is the cause of this issue, otherwise it will be necessary to replace the tensioner or pulley.
I notice bearing noises on the serpentine belt of my Ford S-max 2
Finally, if in your case you distinguish a bearing belt noise on Ford S-max 2, it is possible that it is connected to a serpentine belt that is too tight . Indeed, it is possible that its size may be smaller than prescribed and cause the entire system to overvoltage, resulting in this whistling noise or slight rolling noise. The problem in this case is that the bearing bearings or the Damper pulley may fail . Remember, therefore, to stretch the belt to limit the risks or to replace it if it is too short. If after checking all thoses alternatives, you still detect a belt noises, read our article about timing belt noises on Ford S-max 2 which could maybe help you.
