It is never pleasing to find out a noise from your car you don’t know where from. So what if you discover a serpentine belt noise that persists on your Fiat Bravo? It is very possible that this is a insignificant problem, but before being sure, it is better to carry out some verifications. If this belt noise comes from your serpentine or driving belt, our team has written a document to support you locating and correcting it. First, we will look at the serpentine belt noises on your Fiat Bravo and then we will look at the sources of these sounds.
I encounter noises from serpentine belt Fiat Bravo
The best strategy to control the state of your belts is to listen to your automobile. Immediately after you notice sounds such as squealing or bells, you should take a closer look to verify their source. The job of the serpentine belt or driving belt of your Fiat Bravo is to transfer the movement of the engine to the secondary elements that it will supply with energy. Like steering, air conditioning, water pump. Its role is therefore fundamental in the normal functionality of your automobile. The serpentine belt is said to be asynchronous, i.e. unlike the timing belt, it has the ability to drive different engine elements at variable speeds.
I find out squealing noises on my serpentine belt Fiat Bravo
This sort of squealing belt noises on Fiat Bravo, which will often be acute, can generally occur when the engine is cold, or when the acceleration increases in intensity. . This sort of noise must be heavy and it is often quite simple to associate it with one of these belts. To verify, do not hesitate to open your bonnet, engine running cold and check the source of this noise, the serpentine or driving belt being exposed, it should not be too complicated for you to locate a belt noise on your Fiat Bravo. The cause of this problem can be in connection with the damper pulley, which operates as a damper to eradicate irregularities in the tension in the motor cycle and therefore in the energy transmission to the belt. This results in a loose belt that will jerk. However, you still have the possibility that this event is annodine. As the serpentine belt of your Fiat Bravo is exposed, it may squeak due to excessive humidity due to weather conditions and it may end with a change in conditions. Remember to verify the state of your belt (crack, crack), if this is the case replace it, otherwise simply tighten the belt.
I find out loud serpentine or driving belt noises Fiat Bravo
Just like squealing, a driving belt noise on your Fiat Bravo that sounds like a loud grinding sound can express a lot about its state. It is therefore necessary that you look further and find the cause for this sound that can indicate the end of your belt’s life. Like squealing noise, it can be identified in most cases when cold . It generally means a worn pulley whose streaks no longer allow it to be driven correctly. Other possibilities, the dynamic belt tensioner or the disengageable pulley of the alternator may be at the source of this problem. Remember to verify first the serpentine/driving belt which in most cases is the cause of this problem, otherwise it will be necessary to replace the tensioner or pulley.
I find out bearing noises on the serpentine belt of my Fiat Bravo
Finally, if in your case you recognize a bearing belt noise on Fiat Bravo, it is possible that it is in connection with a serpentine belt that is too tight . Indeed, it is possible that its size may be smaller than recommended and cause the entire system to overvoltage, resulting in this whistling noise or slight rolling noise. The problem in this case is that the bearing bearings or the Damper pulley may fail . Remember, therefore, to stretch the belt to limit the risks or to swap it if it is too short. If after checking all thoses possibilities, you still notice a belt noises, read our article about timing belt noises on Fiat Bravo which could maybe help you.
