It is never pleasing to hear a sound on your automobile that you don’t know where it comes from. You may be questioning what to do when you notice a reversing gear noise that continues on your Renault Master 2? Any gearbox issue can be severe, but before making sure, it is better to do a few investigations. Our team has made this article to support you solve it. First, we will see what the sources and the different gearbox noises can be on Renault Master 2, and second, what are the solutions available to you.
Classical reverse Renault Master 2 noises and some tips to maintain your gearbox
Why does the reversing of my Renault Master 2 make a different noise from my other speeds?
De facto, integrating all gears, bearings and pinions into a gearbox is a difficult task. The noise induced by the reversing of your Renault Master 2 is logical. It can be explained in a fairly simple way. In fact, the gears used for conventional speeds (1st to 5th or 6th) are so-called “helical” gears (oblique gears) . The use of such a pinion makes the noise caused by the gears much less important than with spur gears chosen for the reverse gear.
Tips to limit wear on your clutch and gearbox
- Don’t give a big boost:
In fact, if you kick the throttle hard when you are in reverse or when you put the automobile in the revs, you risk to burn your clutch or gnawing at the gearbox pinions. - Never reverse while the automobile is in motion or vice versa:
Reversing the direction of operation of the gearbox during operation is a very bad plan. In fact, the pressure you will apply on the gears will be monumental and you will generate a premature wear and tear of the gears. You can even destroy the gears of your gearbox at speed by doing so. It will therefore be completely usual if you notice a reverse noise on your Renault Master 2 if you shift gear under these conditions.
Diverse Renault Master 2 reversing noises and their causes
Finally in this section, we will move on to what you are probably most curious about in this article, to find out about the cause of reversing noise on Renault Master 2. Here are the 3 typical sounds you may be victim of.
I notice a grinding noise when starting in reverse gear
If you hear a grinding noise when you start in reverse with your Renault Master 2, it may be the engine mounts that are tired. Indeed, when the engine is in reverse gear, due to the pinions we saw above the vibrations produced by the gearbox are higher and it is therefore conceivable that due to their wear the silentblocks no longer absorb the engine vibrations well. In this case, do not hesitate to check this content for more info about strut mount noises on Renault Master 2.
An increased reverse knocking noise on Renault Master 2X
If you are subject to a knocking noise when you are in reverse with your Renault Master 2 and this noise tends to build up as you gain speed. It is conceivable that you are dealing with a serious issue that needs to be fixed rather quickly before ruining your entire gearbox. In fact, an intensifying rattling noise means that the gears are damaged. If they are, debris will propagate to the rest of the box and damage other gears very fast. Take your automobile to your auto mechanic quickly or check out this article about gearbox noise on Renault Master 2 for more details.
I notice a noise when I go in reverse
Experiencing a noise when you shift into reverse is normal and connected to the gears and sprockets used in the gearbox. If, on the other hand, you have the feeling that your Renault Master 2 reverse gear makes more noise than before, it is conceivable that filings have been made and are moving around in it. It is therefore time to empty the box.
