On occasion your automobile can make noises in the front axle, you are very rarely reassured by this sort of noise and you automatically tend to presume that you will lose a wheel or that the fix will cost you an astronomical amount. Then, what if you identify a noise coming from a gimbals of your Nissan Pulsar? It may not be much and you can fix the trouble yourself, but if in doubt it is better to verify before a larger failure shows up. It is with this in mind that we have chosen to write this document and allow you to locate the trouble and find a treatment. We will, through few steps review all the components that can create noises at the front end of your Nissan Pulsar. 
What are the elements that can cause a noise close to gimbals on Nissan Pulsar?
Most of our work will focus on finding the element that gives your Nissan Pulsar gimbals noise. The following is a list of the components that are most likely to be causing it and how to confirm it.
Noise vibration that sounds like gimbals on Nissan Pulsar : the shock absorber cup
One of the most common causes of noises on Nissan Pulsar that sounds like a gimbals is advanced wear and tear on your shock system. In fact, the suspension cups, when they are dead, the rubber (silentblock) that acts as a buffer and shock absorber for the upper part of the suspension no longer fulfils its role and during small jolts that compress the suspensions. To verify if this is the trouble that concerns you, take a dented, slow-speed road and focus on the noise coming from your front end as you pass over holes. If these are the cups, consider replacing them soon as this may affect other parts and require more expensive repairs.
Noise while turning that sounds like gimbals Nissan Pulsar : stabilizer bar
If you detect of a noise on your Nissan Pulsar that sounds like a gimbals when you are turning flat or going up on sidewalks for example, it is most likely related to one of the parts of your stabilizer bar that is faulty. To confirm the origin of the trouble, you may feel a lack of balance in the direction of the car (it pulls to the left or it pulls to the right). Also, you can position yourself on one side of one of your front wheels then the other and try to shake your wheels strongly, if you hear a clicking sound it is highly imaginable that your silentblocks of stabilizer bar are dead. In this case, go to your mechanic.
Noise when turning Nissan Pulsar : gimbals
One of the most common causes when noise appearsand sounds like gimbals on your Nissan Pulsar when you turn with your car is related to the direction of your car. In fact, the gimbals and their bellows are parts that are constantly stressed during your changes of direction and a wear of one of them can generate “Clac clac” type noises when you reach the stop zone of your direction. A bellows with holes will damage the cardan shaft very quickly and must be replaced very quickly, otherwise it will be necessary to change the entire cardan shaft. Remember to take a look at it and have it repaired if necessary. If it is rather a squeaking noise on your Nissan Pulsar, do not hesitate to consult this article to find the solution to your problem.
