Occasionally your car can make noises in the front axle, you are very hardly ever reassured by this sorts of noise and you immediately tend to think that you will lose a wheel or that the fix will cost you an massive amount. Thus, what if you identify a noise coming from a gimbals of your Mazda 2? It may not be much and you can correct the issue yourself, but if in doubt it is better to verify before a larger troubles shows up. It is with this in mind that we have chosen to write this article and allow you to find the issue and find a treatment. We will, through few steps review all the elements that can create noises at the front end of your Mazda 2. 
What are the elements that can cause a noise close to gimbals on Mazda 2?
Most of our job will focus on finding the element that gives your Mazda 2 gimbals noise. The following is a list of the components that are most likely to be causing it and how to validate it.
Noise vibration that sounds like gimbals on Mazda 2 : the shock absorber cup
One of the most common reason of noises on Mazda 2 that sounds like a gimbals is advanced wear and tear on your suspension system. Indeed, the suspension cups, when they are dead, the rubber (silentblock) that acts as a buffer and shock absorber for the upper part of the suspension no longer assumes its role and during small jolts that compress the suspensions. To verify if this is the issue that worries you, take a dented, slow-speed road and focus on the noise coming from your front end as you pass over holes. If these are the cups, think about changing them quickly as this may damage other parts and require more expensive repairs.
Noise while turning that sounds like gimbals Mazda 2 : stabilizer bar
If you find out of a noise on your Mazda 2 that sounds like a gimbals when you are turning flat or going up on sidewalks for example, it is most likely related to one of the parts of your stabilizer bar that is faulty. To validate the origin of the issue, you may feel a lack of balance in the direction of the automobile (it pulls to the left or it pulls to the right). Moreover, you can position yourself on one side of one of your front wheels then the other and try to shake your wheels powerfully, if you hear a clicking sound it is highly conceivable that your silentblocks of stabilizer bar are dead. In this case, go to your mechanic.
Noise when turning Mazda 2 : gimbals
One of the most common causes when noise appearsand sounds like gimbals on your Mazda 2 when you turn with your automobile is in connection with the direction of your automobile. In fact, the gimbals and their bellows are parts that are constantly stressed during your changes of direction and a wear of one of them can create “Clac clac” type noises when you get closer to the stop zone of your direction. A bellows with holes will damage the cardan shaft very quickly and must be replaced very quickly, otherwise it will be necessary to change the entire cardan shaft. Remember to take a look at it and have it repaired if necessary. If it is rather a squeaking noise on your Mazda 2, do not hesitate to consult this article to find the solution to your problem.
