Occasionally your automobile can make noises in the front axle, you are very rarely reassured by this types of noise and you straightaway tend to presume that you will lose a wheel or that the fix will cost you an astronomical amount. Thus, what if you uncover a noise coming from a gimbals of your Fiat Panda 2? It may not be much and you can fix the problem yourself, but if in doubt it is better to check before a larger problem takes place. It is with this in mind that we have chosen to make this content and allow you to find the problem and find a solution. We will, through few steps review all the elements that can produce noises at the front end of your Fiat Panda 2. 
What are the elements that can cause a noise close to gimbals on Fiat Panda 2?
Most of our article will focus on finding the element that gives your Fiat Panda 2 gimbals noise. The following is a list of the components that are most likely to be causing it and how to verify it.
Noise vibration that sounds like gimbals on Fiat Panda 2 : the shock absorber cup
One of the most likely causes of noises on Fiat Panda 2 that sounds like a gimbals is advanced wear and tear on your suspension system. In fact, the suspension cups, when they are dead, the rubber (silentblock) that acts as a buffer and shock absorber for the upper part of the suspension no longer does its role and during small jolts that compress the suspensions. To check if this is the problem that worries you, take a dented, slow-speed road and listen to the noise coming from your front end as you pass over holes. If these are the cups, think about changing them quickly as this may damage other components and require more expensive repairs.
Noise while turning that sounds like gimbals Fiat Panda 2 : stabilizer bar
If you detect of a noise on your Fiat Panda 2 that sounds like a gimbals when you are turning flat or going up on sidewalks for example, it is most likely connected to one of the parts of your stabilizer bar that is defective. To verify the origin of the problem, you may feel a lack of balance in the direction of the automobile (it pulls to the left or it pulls to the right). Also, you can position yourself on one side of one of your front wheels then the other and try to shake your wheels powerfully, if you hear a clicking sound it is highly imaginable that your silentblocks of stabilizer bar are dead. In this case, go to your garage.
Noise when turning Fiat Panda 2 : gimbals
One of the most common causes when noise shows upand sounds like gimbals on your Fiat Panda 2 when you turn with your automobile is related to the direction of your automobile. Indeed, the gimbals and their bellows are parts that are constantly stressed during your changes of direction and a wear of one of them can generate “Clac clac” type noises when you reach the stop zone of your direction. A bellows with holes will damage the cardan shaft very quickly and must be replaced very quickly, otherwise it will be necessary to change the entire cardan shaft. Remember to take a look at it and have it repaired if necessary. If it is rather a squeaking noise on your Fiat Panda 2, do not hesitate to consult this article to find the solution to your problem.
