It is never enjoyable to listen to a noise from your car you don’t know where from. Then what if you detect a serpentine belt noise that remains on your Dodge Durango? It is extremely conceivable that this is a minor problem, but before being sure, it is better to execute some inspections. If this belt noise comes from your serpentine or driving belt, our team has written a content to help you locating and correcting it. First, we will look at the serpentine belt noises on your Dodge Durango and then we will take a look at the origins of these noises.
I experience noises from serpentine belt Dodge Durango
The best way to check the state of your belts is to listen to your car. Immediately after you perceive noises such as squealing or bells, you should take a closer look to verify their source. The role of the serpentine belt or driving belt of your Dodge Durango is to transfer the movement of the engine to the secondary elements that it will supply with energy. Like steering, air conditioning, water pump. Its role is therefore fundamental in the normal overall performance of your car. The serpentine belt is said to be asynchronous, i.e. unlike the timing belt, it has the capacity to drive different engine elements at variable speeds.
I listen to squealing noises on my serpentine belt Dodge Durango
This kind of squealing belt noises on Dodge Durango, which will often be acute, can generally arise when the engine is cold, or when the acceleration increases in intensity. . This kind of noise must be heavy and it is normally quite simple to associate it with one of these belts. To verify, do not hesitate to open your bonnet, engine running cold and check the source of this noise, the serpentine or driving belt being accessible, it should not be too difficult for you to identify a belt noise on your Dodge Durango. The reason of this problem can be connected to the damper pulley, which works as a damper to eliminate irregularities in the tension in the motor cycle and therefore in the energy transmission to the belt. This results in a loose belt that will jerk. However, you still have an opportunity that this event is annodine. As the serpentine belt of your Dodge Durango is exposed, it may squeak due to excessive humidity due to weather conditions and it may stop with a change in conditions. Remember to verify the state of your belt (crack, crack), if this is the case replace it, otherwise simply tighten the belt.
I listen to loud serpentine or driving belt noises Dodge Durango
Just like squealing, a driving belt noise on your Dodge Durango that sounds like a loud grinding sound can express a lot about its state. It is therefore important that you look further and locate the reason for this sound that can signal the end of your belt’s life. Like squealing noise, it can be identified in most cases when cold . It generally means a worn pulley whose streaks no longer allow it to be driven correctly. Other alternatives, the dynamic belt tensioner or the disengageable pulley of the alternator may be at the source of this problem. Make sure you verify first the serpentine/driving belt which in most cases is the reason of this problem, otherwise it will be necessary to replace the tensioner or pulley.
I listen to bearing noises on the serpentine belt of my Dodge Durango
Finally, if in your case you discern a bearing belt noise on Dodge Durango, it is conceivable that it is connected to a serpentine belt that is too tight . Indeed, it is conceivable that its size may be smaller than suggested and cause the entire system to overvoltage, resulting in this whistling noise or slight rolling noise. The risk in this case is that the bearing bearings or the Damper pulley may fail . Remember, therefore, to stretch the belt to limit the risks or to change it if it is too short. If after checking all thoses alternatives, you still identify a belt noises, read our article about timing belt noises on Dodge Durango which could maybe help you.