If you detect a noise on your car, you are right to be attentive of it and take it seriously, although it is conceivable that nothing significant will results, it is also conceivable that it is the symptom of a more critical repair. A noise that shows up in the trunk of your Peugeot 207 is fortunately more a sign of a small manipulation or fix, rather than a complex one. To help you in your research, we have chosen to write this content page to present you with the most likely solutions to your trouble. First we will see that this trunk noise on your Peugeot 207 can come from accumulated dirt, the trouble can also come from a loose lock and finally, it can even come from a simple rivet that sits inside your bumper.
Noise in the trunk Peugeot 207 : Accumulated dirt that causes poor closing
>
We will therefore begin with a trunk noise on your Peugeot 207 caused by dirt accumulated on your joints, lock for example. In fact, it is conceivable that on a car that is already a few years old and whose cleaning is not always a main concern or that the roads used are not very clean that dirt accumulates at the trunk gasket. This trouble causes a poor closure of the trunk and a noise that can sound like a crack. To verify if you are in this condition, open the trunk of your Peugeot 207, check the state of the gasket that runs around the entire tailgate and clean it with a wet/soap cloth, dry the whole thing and try to close the trunk and take a dentred road to see the improvement. If this is not the case, continue to the other hypotheses that will probably give a solution. It is conceivable however that you have a trunk noise on your Peugeot 207 that is connected to other sources such as shock absorbers, do not hesitate to consult this content page on the noises at the back of a Peugeot 207.
Noise in the trunk of my Peugeot 207 : Loose lock, clicking noise
Second probability, you may also, over time, encounter a locking system that has taken up some play. And this is one of the most likely possibilities. In fact, knowing a trunk noise on your Peugeot 207 is very often connected to this trouble. Different solutions are available to you depending on the level of play you have with your lock. The first is that quite often the offset is minimal and a simple greasing of the mechanism with thick grease is good enough to fix the issue. Secondly, it is also conceivable that you really have a lot of play on your lock and that each time the trunk “jumps”, in which circumstance you would have to strip off the cover that allows access to the lock (inside the trunk). Then, using torx screws, you unscrew the striker attached to the threshold, just push it back a little towards the inside of the trunk and tighten it again. Don’t forget to verify the centering of the striker in connection with the trunk lock. If after checking out the trunk of your Peugeot 207 closes badly, it means that you have moved it too far, repeat the operation by pushing the striker less.
Noise in my trunk Peugeot 207 : Rivet following plate change in the trunk/ bumper
Finally, one of the last possibilities. It is that following a license plate change you were unlucky and that a piece of rivet fell at the rear of your plate. In fact, when a plate replacement is done, to take out the old one the technique used is to drill the existing rivets to be able to release the license plate. Unfortunately, it can happen that part of the rivet falls into the hole of the bumper and it will therefore wander inside the bumper and can cause an annoying noise. To check that it is this problem you are experiencing, and that you have a trunk noise on your Peugeot 207 linked to a rivet, you will need to verify that it is in the tailgate open it and stir it to define the noise. If this is your case, you will have to remove the linings from the trunk to remove it. Finally, if it is your bumper, it is in this rarer and more embarrassing case, you will have to take out the bumper to remove the bits of rivet that are running around.
