If you find a noise on your automobile, you are right to be concerned of it and take it seriously, although it is conceivable that nothing critical will occur, it is also conceivable that it is the sign of a more important fix. A noise that appears in the trunk of your Peugeot 2008 is luckily more a sign of a small manipulation or service, rather than a complicated one. To help you in your research, we have decided to generate this content to present you with the most likely solutions to your issue. First we will see that this trunk noise on your Peugeot 2008 can come from built up dirt, the issue can also come from a loose lock and finally, it can even come from a simple rivet that sits inside your bumper.
Noise in the trunk Peugeot 2008 : Built up dirt that causes poor closing
>
We will therefore start with a trunk noise on your Peugeot 2008 created by dirt accumulated on your joints, lock for example. In fact, it is conceivable that on a automobile that is already a few years old and whose cleaning is not always a top priority or that the roads used are not very clean that dirt builds up at the trunk gasket. This issue causes a poor closure of the trunk and a noise that can sound like a crack. To check if you are in this scenario, open the trunk of your Peugeot 2008, check the state of the gasket that goes around the entire tailgate and clean it with a wet/soap cloth, dry the whole thing and try to close the trunk and take a dentred road to see the difference. If this is not the case, continue to the other hypotheses that will probably give a solution. It is conceivable however that you have a trunk noise on your Peugeot 2008 that is linked to other origins such as shock absorbers, do not hesitate to read this content on the noises at the back of a Peugeot 2008.
Noise in the trunk of my Peugeot 2008 : Loose lock, clicking noise
Second probability, you may also, over time, encounter a locking system that has taken up some play. And this is one of the most likely possibilities. In fact, knowing a trunk noise on your Peugeot 2008 is very frequently linked to this issue. Several solutions are available to you depending on the level of play you have with your lock. The first is that quite often the offset is minimal and a simple greasing of the system with thick grease is appropriate to eliminate the issue. Secondly, it is also conceivable that you really have a lot of play on your lock and that each time the trunk “jumps”, in which circumstance you would have to remove the cover that allows access to the lock (inside the trunk). Then, using torx screws, you unscrew the striker attached to the threshold, just push it back a little towards the inside of the trunk and tighten it again. Remember to check the centering of the striker in relation to the trunk lock. If after checking the trunk of your Peugeot 2008 closes badly, it means that you have moved it too far, repeat the process by pushing the striker less.
Noise in my trunk Peugeot 2008 : Rivet following plate change in the trunk/ bumper
Finally, one of the last possibilities. It is that following a license plate change you were unfortunate and that a piece of rivet fell backside your plate. In fact, when a plate replacement is made, to remove the old one the technique used is to drill the existing rivets in order to put out the license plate. Sadly, it can happen that part of the rivet falls into the hole of the bumper and it will therefore wander inside the bumper and can induce an annoying noise. To check that it is this problem you are experiencing, and that you have a trunk noise on your Peugeot 2008 linked to a rivet, you will need to check that it is in the tailgate open it and stir it to discern the noise. If this is your situation, you will have to take out the linings from the trunk to remove it. Finally, if it is your bumper, it is in this rarer and more problematic situation, you will have to remove the bumper to remove the bits of rivet that are running around.
