If you find out a noise on your vehicle, you are right to be aware of it and take it seriously, although it is conceivable that nothing major will results, it is also conceivable that it is the sign of a more significant fix. A noise that occurs in the trunk of your Audi Q2 is thankfully more a indicator of a small adjustment or repair, rather than a complicated one. To support you in your research, we have decided to write this content page to present you with the most likely solutions to your problem. First we will see that this trunk noise on your Audi Q2 can come from accumulated dirt, the problem can also come from a loose lock and finally, it can even come from a simple rivet that sits inside your bumper.
Noise in the trunk Audi Q2 : Built up dirt that triggers poor closing
>
We will therefore begin with a trunk noise on your Audi Q2 triggered by dirt accumulated on your joints, lock for example. In fact, it is conceivable that on a vehicle that is already a few years old and whose cleaning is not always a main concern or that the roads used are not very clean that dirt builds up at the trunk gasket. This problem triggers a poor closure of the trunk and a noise that can sound like a crack. To check if you are in this condition, open the trunk of your Audi Q2, examine the state of the gasket that goes around the entire tailgate and clean it with a wet/soap cloth, dry the whole thing and try to close the trunk and take a dentred road to see the improvement. If this is not the case, continue to the other hypotheses that will probably give a solution. It is conceivable however that you have a trunk noise on your Audi Q2 that is relating to other sources such as shock absorbers, do not hesitate to read this content page on the noises at the back of a Audi Q2.
Noise in the trunk of my Audi Q2 : Loose lock, clicking noise
Second possibility, you may also, over time, knowledge a locking system that has taken up some play. And this is one of the most potential alternatives. In fact, knowing a trunk noise on your Audi Q2 is very frequently relating to this problem. Several solutions are available to you subject to the level of play you have with your lock. The first is that occasionally the offset is minimal and a simple greasing of the system with thick grease is appropriate to eliminate the trouble. Secondly, it is also conceivable that you really have a lot of play on your lock and that each time the trunk “jumps”, in which circumstance you would have to take off the cover that allows access to the lock (inside the trunk). Then, using torx screws, you unscrew the striker attached to the threshold, just push it back a little towards the inside of the trunk and tighten it again. Remember to check the centering of the striker in relation to the trunk lock. If after checking the trunk of your Audi Q2 closes badly, it means that you have moved it too far, duplicate the procedure by pushing the striker less.
Noise in my trunk Audi Q2 : Rivet following plate change in the trunk/ bumper
Finally, one of the last possibilities. It is that following a license plate change you were unfortunate and that a piece of rivet fell backside your plate. In fact, when a plate replacement is done, to take off the old one the procedure used is to drill the existing rivets to be able to release the license plate. Unfortunately, it can happen that part of the rivet falls into the hole of the bumper and it will therefore wander inside the bumper and can generate an annoying noise. To check that it is this problem you are experiencing, and that you have a trunk noise on your Audi Q2 linked to a rivet, you will need to check that it is in the tailgate open it and stir it to identify the noise. If this is your case, you will have to remove the linings from the trunk to remove it. Finally, if it is your bumper, it is in this rarer and more disturbing case, you will have to take off the bumper to remove the bits of rivet that are running around.
