If you detect a noise on your car, you are right to be aware of it and take it seriously, although it is conceivable that nothing significant will happen, it is also conceivable that it is the indication of a more important repair. A noise that comes out in the trunk of your Toyota Land Cruiser Serie 150 is fortunately more a indication of a small manipulation or repair, rather than a complicated one. To support you in your research, we have decided to produce this content to present you with the most likely solutions to your issue. First we will see that this trunk noise on your Toyota Land Cruiser Serie 150 can come from accumulated dirt, the issue can also come from a loose lock and finally, it can even come from a simple rivet that sits inside your bumper.
Noise in the trunk Toyota Land Cruiser Serie 150 : Accumulated dirt that triggers poor closing
>
We will therefore begin with a trunk noise on your Toyota Land Cruiser Serie 150 induced by dirt accumulated on your joints, lock for example. Indeed, it is conceivable that on a car that is already a few years old and whose cleaning is not always a main concern or that the roads used are not very clean that dirt accumulates at the trunk gasket. This issue triggers a poor closure of the trunk and a noise that can sound like a crack. To verify if you are in this scenario, open the trunk of your Toyota Land Cruiser Serie 150, check the state of the gasket that runs around the entire tailgate and clean it with a wet/soap cloth, dry the whole thing and try to close the trunk and take a dentred road to see the difference. If this is not the case, continue to the other hypotheses that will probably give a solution. It is conceivable however that you have a trunk noise on your Toyota Land Cruiser Serie 150 that is relating to other sources such as shock absorbers, do not hesitate to read this content on the noises at the back of a Toyota Land Cruiser Serie 150.
Noise in the trunk of my Toyota Land Cruiser Serie 150 : Loose lock, clicking noise
Second probability, you may also, over time, encounter a locking system that has taken up some play. And this is one of the most potential possibilities. Indeed, knowing a trunk noise on your Toyota Land Cruiser Serie 150 is very often relating to this issue. Several solutions are existing to you depending on the level of play you have with your lock. The first is that sometimes the offset is minimal and a simple greasing of the mechanism with thick grease is sufficient to resolve the issue. Secondly, it is also conceivable that you really have a lot of play on your lock and that each time the trunk “jumps”, in which circumstance you would have to take off the cover that permits access to the lock (inside the trunk). Then, using torx screws, you unscrew the striker attached to the threshold, simply push it back a little towards the inside of the trunk and tighten it again. Remember to verify the centering of the striker in regards to the trunk lock. If after checking out the trunk of your Toyota Land Cruiser Serie 150 closes badly, it means that you have moved it too far, repeat the operation by pushing the striker less.
Noise in my trunk Toyota Land Cruiser Serie 150 : Rivet following plate swap in the trunk/ bumper
Finally, one of the last possibilities. It is that following a license plate swap you were unlucky and that a piece of rivet fell at the rear of your plate. Indeed, when a plate replacement is made, to take off the old one the technique used is to drill the existing rivets in order to released the license plate. Unfortunately, it can happen that part of the rivet falls into the hole of the bumper and it will therefore wander inside the bumper and can trigger an annoying noise. To check that it is this problem you are experiencing, and that you have a trunk noise on your Toyota Land Cruiser Serie 150 linked to a rivet, you will need to verify that it is in the tailgate open it and stir it to discern the noise. If this is your case, you will have to remove the linings from the trunk to remove it. Finally, if it is your bumper, it is in this rarer and more problematic case, you will have to take off the bumper to remove the bits of rivet that are running around.
