If you find out a noise on your vehicle, you are right to be aware of it and take it seriously, although it is conceivable that nothing critical will results, it is also conceivable that it is the indication of a more critical repair. A noise that occurs in the trunk of your Audi Q8 is fortunately more a indicator of a small correction or service, rather than a complicated one. To support you in your research, we have decided to write this content page to present you with the most likely solutions to your issue. First we will see that this trunk noise on your Audi Q8 can come from built up dirt, the issue can also come from a loose lock and finally, it can even come from a simple rivet that sits inside your bumper.
Noise in the trunk Audi Q8 : Built up dirt that causes poor closing
>
We will therefore start with a trunk noise on your Audi Q8 caused by dirt accumulated on your joints, lock for example. Indeed, it is conceivable that on a vehicle that is already a few years old and whose cleaning is not always a priority or that the roads used are not very clean that dirt accumulates at the trunk gasket. This issue causes a poor closure of the trunk and a noise that can sound like a crack. To verify if you are in this circumstance, open the trunk of your Audi Q8, verify the condition of the gasket that goes around the entire tailgate and clean it with a wet/soap cloth, dry the whole thing and try to close the trunk and take a dentred road to see the improvement. If this is not the case, continue to the other hypotheses that will probably give a solution. It is conceivable however that you have a trunk noise on your Audi Q8 that is relating to other sources such as shock absorbers, do not hesitate to read this content page on the noises at the back of a Audi Q8.
Noise in the trunk of my Audi Q8 : Loose lock, clicking noise
Second probability, you may also, over time, experience a locking system that has taken up some play. And this is one of the most likely possibilities. Indeed, knowing a trunk noise on your Audi Q8 is very often relating to this issue. Some solutions are available to you according to the level of play you have with your lock. The first is that occasionally the offset is minimal and a simple greasing of the system with thick grease is enough to fix the problem. Secondly, it is also conceivable that you really have a lot of play on your lock and that each time the trunk “jumps”, in which case you would have to remove the cover that permits access to the lock (inside the trunk). Then, using torx screws, you unscrew the striker attached to the threshold, simply push it back a little towards the inside of the trunk and tighten it again. Remember to verify the centering of the striker in regards to the trunk lock. If after checking the trunk of your Audi Q8 closes badly, it means that you have moved it too far, replicate the process by pushing the striker less.
Noise in my trunk Audi Q8 : Rivet following plate swap in the trunk/ bumper
Finally, one of the last possibilities. It is that following a license plate swap you were unfortunate and that a piece of rivet fell at the rear of your plate. Indeed, when a plate swap is made, to take off the old one the process used is to drill the existing rivets to be able to released the license plate. Sadly, it can happen that part of the rivet falls into the hole of the bumper and it will therefore wander inside the bumper and can cause an annoying noise. To check that it is this problem you are experiencing, and that you have a trunk noise on your Audi Q8 linked to a rivet, you will need to verify that it is in the tailgate open it and stir it to discern the noise. If this is your situation, you will have to take out the linings from the trunk to remove it. Finally, if it is your bumper, it is in this rarer and more disturbing situation, you will have to take off the bumper to remove the bits of rivet that are running around.
