It is never relaxing to notice a noise from your car you don’t know where from. Then what if you identify a serpentine belt noise that lasts on your Citroen Jumper 2? It is very possible that this is a minimal issue, but before being sure, it is better to execute some verifications. If this belt noise comes from your serpentine or driving belt, our team has written a page to help you finding and solving it. First, we will look at the serpentine belt noises on your Citroen Jumper 2 and then we will take a look at the sources of these sounds.
I experience noises from serpentine belt Citroen Jumper 2
The best way to check the condition of your belts is to listen to your automobile. Immediately after you recognise sounds such as squealing or bells, you should take a closer look to verify their source. The function of the serpentine belt or driving belt of your Citroen Jumper 2 is to transmit the movement of the engine to the secondary elements that it will supply with energy. Like steering, air conditioning, water pump. Its role is therefore important in the normal general performance of your automobile. The serpentine belt is said to be asynchronous, i.e. unlike the timing belt, it has the capacity to drive distinctive engine elements at variable speeds.
I notice squealing noises on my serpentine belt Citroen Jumper 2
This kind of squealing belt noises on Citroen Jumper 2, which will often be acute, can mostly occur when the engine is cold, or when the acceleration increases in intensity. . This kind of noise must be significant and it is normally quite simple to connect it with one of these belts. To verify, do not hesitate to open your bonnet, engine running cold and check the source of this noise, the serpentine or driving belt being visible, it should not be too difficult for you to locate a belt noise on your Citroen Jumper 2. The reason of this issue can be related to the damper pulley, which functions as a damper to reduce irregularities in the tension in the motor cycle and therefore in the energy transmission to the belt. This results in a loose belt that will jerk. However, you still have a chance that this event is annodine. As the serpentine belt of your Citroen Jumper 2 is exposed, it may squeak due to excessive humidity due to weather conditions and it may stop with a change in conditions. Keep in mind to verify the condition of your belt (crack, crack), if this is the case change it, otherwise simply tighten the belt.
I notice loud serpentine or driving belt noises Citroen Jumper 2
Just like squealing, a driving belt noise on your Citroen Jumper 2 that sounds like a loud grinding sound can say a lot about its condition. It is therefore important that you look further and locate the cause for this sound that can signal the end of your belt’s life. Like squealing noise, it can be identified in most cases when cold . It generally means a worn pulley whose streaks no longer allow it to be driven properly. Other alternatives, the dynamic belt tensioner or the disengageable pulley of the alternator may be at the source of this issue. Don’t forget to verify first the serpentine/driving belt which in most cases is the reason of this issue, otherwise it will be necessary to change the tensioner or pulley.
I notice bearing noises on the serpentine belt of my Citroen Jumper 2
Finally, if in your case you identify a bearing belt noise on Citroen Jumper 2, it is possible that it is related to a serpentine belt that is too tight . Indeed, it is possible that its size may be smaller than suggested and cause the entire system to overvoltage, resulting in this whistling noise or slight rolling noise. The problem in this case is that the bearing bearings or the Damper pulley may fail . Remember, therefore, to stretch the belt to limit the risks or to swap it if it is too short. If after checking all thoses alternatives, you still identify a belt noises, read our article about timing belt noises on Citroen Jumper 2 which could maybe help you.
