It is never pleasant to find out a noise from your car you don’t know where from. Thus what if you detect a serpentine belt noise that remains on your Volvo V50? It is highly conceivable that this is a unimportant issue, but before being sure, it is better to accomplish some investigations. If this belt noise comes from your serpentine or driving belt, our team has written a page to help you locating and fixing it. First, we will look at the serpentine belt noises on your Volvo V50 and then we will check out the sources of these sounds.
I experience noises from serpentine belt Volvo V50
The best strategy to check the state of your belts is to listen to your vehicle. Immediately after you notice sounds such as squealing or bells, you should take a closer look to examine their origin. The role of the serpentine belt or driving belt of your Volvo V50 is to transmit the movement of the engine to the secondary components that it will supply with energy. Like steering, air conditioning, water pump. Its role is therefore vital in the normal operation of your vehicle. The serpentine belt is said to be asynchronous, i.e. unlike the timing belt, it has the ability to drive distinctive engine components at variable speeds.
I find out squealing noises on my serpentine belt Volvo V50
This type of squealing belt noises on Volvo V50, which will often be acute, can in most cases arise when the engine is cold, or when the acceleration increases in intensity. . This type of noise must be significant and it is often quite simple to associate it with one of these belts. To examine, do not hesitate to open your bonnet, engine running cold and check the origin of this noise, the serpentine or driving belt being visible, it should not be too difficult for you to point a belt noise on your Volvo V50. The cause of this issue can be in connection with the damper pulley, which works as a damper to reduce irregularities in the tension in the motor cycle and therefore in the energy transmission to the belt. This results in a loose belt that will jerk. However, you still have the possibility that this phenomenon is annodine. As the serpentine belt of your Volvo V50 is exposed, it may squeak due to excessive humidity due to weather conditions and it may end with a change in conditions. Remember to examine the state of your belt (crack, crack), if this is the case replace it, otherwise simply tighten the belt.
I find out loud serpentine or driving belt noises Volvo V50
Just like squealing, a driving belt noise on your Volvo V50 that sounds like a loud grinding sound can express a lot about its state. It is therefore necessary that you look further and locate the reason for this sound that can signal the end of your belt’s life. Like squealing noise, it can be identified in most cases when cold . It generally means a worn pulley whose streaks no longer allow it to be driven properly. Other alternatives, the dynamic belt tensioner or the disengageable pulley of the alternator may be at the origin of this issue. Make sure you examine first the serpentine/driving belt which in most cases is the cause of this issue, otherwise it will be necessary to replace the tensioner or pulley.
I find out bearing noises on the serpentine belt of my Volvo V50
Finally, if in your case you distinguish a bearing belt noise on Volvo V50, it is conceivable that it is in connection with a serpentine belt that is too tight . Indeed, it is conceivable that its size may be smaller than prescribed and cause the entire system to overvoltage, resulting in this whistling noise or slight rolling noise. The problem in this case is that the bearing bearings or the Damper pulley may fail . Remember, therefore, to stretch the belt to limit the risks or to swap it if it is too short. If after checking all thoses alternatives, you still identify a belt noises, read our article about timing belt noises on Volvo V50 which could maybe help you.
