It is never pleasing to find out a noise from your car you don’t know where from. Then what if you locate a serpentine belt noise that stays on your Peugeot Partner Tepee? It is very plausible that this is a minor problem, but before being sure, it is better to accomplish some verifications. If this belt noise comes from your serpentine or driving belt, our team has written a post to help you locating and repairing it. First, we will look at the serpentine belt noises on your Peugeot Partner Tepee and then we will check out the sources of these noises.
I feel noises from serpentine belt Peugeot Partner Tepee
The best way to control the state of your belts is to listen to your vehicle. Immediately after you detect noises such as squealing or bells, you should take a closer look to verify their origin. The role of the serpentine belt or driving belt of your Peugeot Partner Tepee is to transfer the movement of the engine to the secondary components that it will supply with energy. Like steering, air conditioning, water pump. Its role is therefore important in the normal general performance of your vehicle. The serpentine belt is said to be asynchronous, i.e. unlike the timing belt, it has the capacity to drive different engine components at variable speeds.
I find out squealing noises on my serpentine belt Peugeot Partner Tepee
This type of squealing belt noises on Peugeot Partner Tepee, which will often be acute, can generally arise when the engine is cold, or when the acceleration increases in intensity. . This type of noise must be significant and it is obviously quite simple to relate it with one of these belts. To verify, do not hesitate to open your bonnet, engine running cold and check the origin of this noise, the serpentine or driving belt being visible, it should not be too difficult for you to spot a belt noise on your Peugeot Partner Tepee. The reason of this problem can be linked to the damper pulley, which works as a damper to eliminate irregularities in the tension in the motor cycle and therefore in the energy transmission to the belt. This results in a loose belt that will jerk. However, you still have the possibility that this event is annodine. As the serpentine belt of your Peugeot Partner Tepee is exposed, it may squeak due to excessive humidity due to weather conditions and it may end with a change in conditions. Keep in mind to verify the state of your belt (crack, crack), if this is the case replace it, otherwise simply tighten the belt.
I find out loud serpentine or driving belt noises Peugeot Partner Tepee
Just like squealing, a driving belt noise on your Peugeot Partner Tepee that sounds like a loud grinding sound can say a lot about its state. It is therefore important that you look further and find the cause for this sound that can signal the end of your belt’s life. Like squealing noise, it can be identified in most cases when cold . It generally means a worn pulley whose streaks no longer allow it to be driven properly. Other possibilities, the dynamic belt tensioner or the disengageable pulley of the alternator may be at the origin of this problem. Remember to verify first the serpentine/driving belt which in most cases is the reason of this problem, otherwise it will be necessary to replace the tensioner or pulley.
I find out bearing noises on the serpentine belt of my Peugeot Partner Tepee
Finally, if in your case you recognize a bearing belt noise on Peugeot Partner Tepee, it is plausible that it is linked to a serpentine belt that is too tight . Indeed, it is plausible that its size may be smaller than recommended and cause the entire system to overvoltage, resulting in this whistling noise or slight rolling noise. The risk in this case is that the bearing bearings or the Damper pulley may fail . Remember, therefore, to stretch the belt to limit the risks or to change it if it is too short. If after checking all thoses possibilities, you still identify a belt noises, read our article about timing belt noises on Peugeot Partner Tepee which could maybe help you.
