It is never pleasing to notice a noise from your car you don’t know where from. Thus what if you identify a serpentine belt noise that persists on your Mitsubishi Space star 2? It is extremely possible that this is a insignificant issue, but before being sure, it is better to operate some inspections. If this belt noise comes from your serpentine or driving belt, our team has written a content to help you finding and fixing it. First, we will look at the serpentine belt noises on your Mitsubishi Space star 2 and then we will look at the sources of these sounds.
I encounter noises from serpentine belt Mitsubishi Space star 2
The best method to control the state of your belts is to listen to your vehicle. Immediately after you find sounds such as squealing or bells, you should take a closer look to examine their origin. The job of the serpentine belt or driving belt of your Mitsubishi Space star 2 is to transfer the movement of the engine to the secondary parts that it will supply with energy. Like steering, air conditioning, water pump. Its role is therefore fundamental in the normal overall performance of your vehicle. The serpentine belt is said to be asynchronous, i.e. unlike the timing belt, it has the capacity to drive different engine parts at variable speeds.
I notice squealing noises on my serpentine belt Mitsubishi Space star 2
This sort of squealing belt noises on Mitsubishi Space star 2, which will often be acute, can in most cases appear when the engine is cold, or when the acceleration increases in intensity. . This sort of noise must be significant and it is normally quite simple to associate it with one of these belts. To examine, do not hesitate to open your bonnet, engine running cold and check the origin of this noise, the serpentine or driving belt being exposed, it should not be too difficult for you to point a belt noise on your Mitsubishi Space star 2. The cause of this issue can be linked to the damper pulley, which operates as a damper to eliminate irregularities in the tension in the motor cycle and therefore in the energy transmission to the belt. This results in a loose belt that will jerk. However, you still have a chance that this event is annodine. As the serpentine belt of your Mitsubishi Space star 2 is exposed, it may squeak due to excessive humidity due to weather conditions and it may stop with a change in conditions. Keep in mind to examine the state of your belt (crack, crack), if this is the case swap it, otherwise simply tighten the belt.
I notice loud serpentine or driving belt noises Mitsubishi Space star 2
Just like squealing, a driving belt noise on your Mitsubishi Space star 2 that sounds like a loud grinding sound can reveal a lot about its state. It is therefore necessary that you look further and find the reason for this sound that can indicate the end of your belt’s life. Like squealing noise, it can be identified in most cases when cold . It generally means a worn pulley whose streaks no longer allow it to be driven properly. Other alternatives, the dynamic belt tensioner or the disengageable pulley of the alternator may be at the origin of this issue. Don’t forget to examine first the serpentine/driving belt which in most cases is the cause of this issue, otherwise it will be necessary to swap the tensioner or pulley.
I notice bearing noises on the serpentine belt of my Mitsubishi Space star 2
Finally, if in your case you identify a bearing belt noise on Mitsubishi Space star 2, it is possible that it is linked to a serpentine belt that is too tight . Indeed, it is possible that its size may be smaller than prescribed and cause the entire system to overvoltage, resulting in this whistling noise or slight rolling noise. The problem in this case is that the bearing bearings or the Damper pulley may fail . Remember, therefore, to stretch the belt to limit the risks or to swap it if it is too short. If after checking all thoses alternatives, you still perceive a belt noises, read our article about timing belt noises on Mitsubishi Space star 2 which could maybe help you.
