It is never pleasurable to find out a noise from your car you don’t know where from. Thus what if you identify a serpentine belt noise that persists on your Mercedes Classe C 4? It is extremely possible that this is a minor trouble, but before being sure, it is better to accomplish some checks. If this belt noise comes from your serpentine or driving belt, our team has written an article to help you locating and fixing it. First, we will look at the serpentine belt noises on your Mercedes Classe C 4 and then we will take a look at the sources of these sounds.
I feel noises from serpentine belt Mercedes Classe C 4
The best method to control the condition of your belts is to listen to your car. Immediately after you detect sounds such as squealing or bells, you should take a closer look to verify their source. The role of the serpentine belt or driving belt of your Mercedes Classe C 4 is to transfer the movement of the engine to the secondary components that it will supply with energy. Like steering, air conditioning, water pump. Its role is therefore important in the normal operation of your car. The serpentine belt is said to be asynchronous, i.e. unlike the timing belt, it has the capacity to drive different engine components at variable speeds.
I find out squealing noises on my serpentine belt Mercedes Classe C 4
This type of squealing belt noises on Mercedes Classe C 4, which will often be acute, can usually appear when the engine is cold, or when the acceleration increases in intensity. . This type of sound must be significant and it is normally quite simple to link it with one of these belts. To verify, do not hesitate to open your bonnet, engine running cold and check the source of this noise, the serpentine or driving belt being apparent, it should not be too difficult for you to locate a belt noise on your Mercedes Classe C 4. The reason of this trouble can be connected to the damper pulley, which works as a damper to reduce irregularities in the tension in the motor cycle and therefore in the energy transmission to the belt. This results in a loose belt that will jerk. However, you still have a chance that this event is annodine. As the serpentine belt of your Mercedes Classe C 4 is exposed, it may squeak due to excessive humidity due to weather conditions and it may end with a change in conditions. Keep in mind to verify the condition of your belt (crack, crack), if this is the case swap it, otherwise simply tighten the belt.
I find out loud serpentine or driving belt noises Mercedes Classe C 4
Just like squealing, a driving belt noise on your Mercedes Classe C 4 that sounds like a loud grinding sound can reveal a lot about its condition. It is therefore essential that you look further and locate the reason for this sound that can signal the end of your belt’s life. Like squealing noise, it can be identified in most cases when cold . It generally means a worn pulley whose streaks no longer allow it to be driven correctly. Other possibilities, the dynamic belt tensioner or the disengageable pulley of the alternator may be at the source of this trouble. Remember to verify first the serpentine/driving belt which in most cases is the reason of this trouble, otherwise it will be necessary to swap the tensioner or pulley.
I find out bearing noises on the serpentine belt of my Mercedes Classe C 4
Finally, if in your case you recognize a bearing belt noise on Mercedes Classe C 4, it is possible that it is connected to a serpentine belt that is too tight . Indeed, it is possible that its size may be smaller than suggested and cause the entire system to overvoltage, resulting in this whistling noise or slight rolling noise. The risk in this case is that the bearing bearings or the Damper pulley may fail . Remember, therefore, to stretch the belt to limit the risks or to swap it if it is too short. If after checking all thoses possibilities, you still identify a belt noises, read our article about timing belt noises on Mercedes Classe C 4 which could maybe help you.
