It is never relaxing to discover a noise from your car you don’t know where from. Then what if you detect a serpentine belt noise that stays on your Fiat Panda 3? It is highly conceivable that this is a minimal trouble, but before being sure, it is better to execute some investigations. If this belt noise comes from your serpentine or driving belt, our team has written a content to help you locating and solving it. First, we will look at the serpentine belt noises on your Fiat Panda 3 and then we will look at the sources of these sounds.
I encounter noises from serpentine belt Fiat Panda 3
The best method to check the condition of your belts is to listen to your car. Immediately after you detect sounds such as squealing or bells, you should take a closer look to check their source. The role of the serpentine belt or driving belt of your Fiat Panda 3 is to transfer the movement of the engine to the secondary components that it will supply with energy. Like steering, air conditioning, water pump. Its role is therefore essential in the normal functionality of your car. The serpentine belt is said to be asynchronous, i.e. unlike the timing belt, it has the ability to drive different engine components at variable speeds.
I discover squealing noises on my serpentine belt Fiat Panda 3
This kind of squealing belt noises on Fiat Panda 3, which will often be acute, can generally occur when the engine is cold, or when the acceleration increases in intensity. . This kind of sound must be significant and it is obviously quite simple to associate it with one of these belts. To check, do not hesitate to open your bonnet, engine running cold and check the source of this noise, the serpentine or driving belt being exposed, it should not be too complicated for you to spot a belt noise on your Fiat Panda 3. The cause of this trouble can be related to the damper pulley, which works as a damper to reduce irregularities in the tension in the motor cycle and therefore in the energy transmission to the belt. This results in a loose belt that will jerk. However, you still have the possibility that this event is annodine. As the serpentine belt of your Fiat Panda 3 is exposed, it may squeak due to excessive humidity due to weather conditions and it may stop with a change in conditions. Keep in mind to check the condition of your belt (crack, crack), if this is the case replace it, otherwise simply tighten the belt.
I discover loud serpentine or driving belt noises Fiat Panda 3
Just like squealing, a driving belt noise on your Fiat Panda 3 that sounds like a loud grinding sound can tell you a lot about its condition. It is therefore important that you look further and locate the reason for this sound that can signal the end of your belt’s life. Like squealing noise, it can be identified in most cases when cold . It generally means a worn pulley whose streaks no longer allow it to be driven correctly. Other possibilities, the dynamic belt tensioner or the disengageable pulley of the alternator may be at the source of this trouble. Make sure to check first the serpentine/driving belt which in most cases is the cause of this trouble, otherwise it will be necessary to replace the tensioner or pulley.
I discover bearing noises on the serpentine belt of my Fiat Panda 3
Finally, if in your case you recognize a bearing belt noise on Fiat Panda 3, it is conceivable that it is related to a serpentine belt that is too tight . Indeed, it is conceivable that its size may be smaller than prescribed and cause the entire system to overvoltage, resulting in this whistling noise or slight rolling noise. The risk in this case is that the bearing bearings or the Damper pulley may fail . Remember, therefore, to stretch the belt to limit the risks or to swap it if it is too short. If after checking all thoses possibilities, you still notice a belt noises, read our article about timing belt noises on Fiat Panda 3 which could maybe help you.
