If you pay attention to a noise on your car, you are right to be aware of it and take it seriously, although it is conceivable that nothing significant will occur, it is also conceivable that it is the sign of a more critical fix. A noise that appears in the trunk of your Ford E Series is luckily more a signal of a small correction or service, rather than a difficult one. To support you in your research, we have chosen to write this article to present you with the most likely solutions to your problem. First we will see that this trunk noise on your Ford E Series can come from built up dirt, the problem can also come from a loose lock and finally, it can even come from a simple rivet that sits inside your bumper.
Noise in the trunk Ford E Series : Built up dirt that causes poor closing
>
We will therefore begin with a trunk noise on your Ford E Series created by dirt accumulated on your joints, lock for example. In fact, it is conceivable that on a car that is already a few years old and whose cleaning is not always a main concern or that the roads used are not very clean that dirt builds up at the trunk gasket. This problem causes a poor closure of the trunk and a noise that can sound like a crack. To examine if you are in this scenario, open the trunk of your Ford E Series, examine the state of the gasket that runs around the entire tailgate and clean it with a wet/soap cloth, dry the whole thing and try to close the trunk and take a dentred road to see the difference. If this is not the case, continue to the other hypotheses that will probably give a solution. It is conceivable however that you have a trunk noise on your Ford E Series that is related to other origins such as shock absorbers, do not hesitate to have a look to this article on the noises at the back of a Ford E Series.
Noise in the trunk of my Ford E Series : Loose lock, clicking noise
Second possibility, you may also, over time, knowledge a locking system that has taken up some play. And this is one of the most potential alternatives. In fact, knowing a trunk noise on your Ford E Series is very frequently related to this problem. Some solutions are existing to you according to the level of play you have with your lock. The first is that in some cases the offset is minimal and a simple greasing of the mechanism with thick grease is appropriate to resolve the issue. Secondly, it is also conceivable that you really have a lot of play on your lock and that each time the trunk “jumps”, in which case you would have to take off the cover that enables access to the lock (inside the trunk). Then, using torx screws, you unscrew the striker attached to the threshold, just push it back a little towards the inside of the trunk and tighten it again. Remember to examine the centering of the striker in regards to the trunk lock. If after checking out the trunk of your Ford E Series closes badly, it means that you have moved it too far, duplicate the operation by pushing the striker less.
Noise in my trunk Ford E Series : Rivet following plate change in the trunk/ bumper
Finally, one of the last possibilities. It is that following a license plate change you were unlucky and that a piece of rivet fell at the rear of your plate. In fact, when a plate swap is made, to remove the old one the strategy used is to drill the existing rivets in order to release the license plate. Unfortunately, it can happen that part of the rivet falls into the hole of the bumper and it will therefore wander inside the bumper and can cause an annoying noise. To check that it is this problem you are experiencing, and that you have a trunk noise on your Ford E Series linked to a rivet, you will need to examine that it is in the tailgate open it and stir it to distinguish the noise. If this is your situation, you will have to remove the linings from the trunk to remove it. Finally, if it is your bumper, it is in this rarer and more disturbing situation, you will have to remove the bumper to remove the bits of rivet that are running around.
