If you detect a noise on your vehicle, you are right to be careful of it and take it seriously, although it is conceivable that nothing serious will happen, it is also conceivable that it is the signal of a more significant restoration. A noise that happens in the trunk of your Toyota Tacoma is thankfully more a signal of a small manipulation or service, rather than a complicated one. To support you in your research, we have decided to generate this content to present you with the most likely solutions to your issue. First we will see that this trunk noise on your Toyota Tacoma can come from built up dirt, the issue can also come from a loose lock and finally, it can even come from a simple rivet that sits inside your bumper.
Noise in the trunk Toyota Tacoma : Built up dirt that triggers poor closing
>
We will therefore begin with a trunk noise on your Toyota Tacoma induced by dirt accumulated on your joints, lock for example. Indeed, it is conceivable that on a vehicle that is already a few years old and whose cleaning is not always a main concern or that the roads used are not very clean that dirt accumulates at the trunk gasket. This issue triggers a poor closure of the trunk and a noise that can sound like a crack. To examine if you are in this situation, open the trunk of your Toyota Tacoma, verify the state of the gasket that runs around the entire tailgate and clean it with a wet/soap cloth, dry the whole thing and try to close the trunk and take a dentred road to see the improvement. If this is not the case, continue to the other hypotheses that will probably give a solution. It is conceivable however that you have a trunk noise on your Toyota Tacoma that is relating to other origins such as shock absorbers, do not hesitate to read this content on the noises at the back of a Toyota Tacoma.
Noise in the trunk of my Toyota Tacoma : Loose lock, clicking noise
Second probability, you may also, over time, knowledge a locking system that has taken up some play. And this is one of the most probably alternatives. Indeed, knowing a trunk noise on your Toyota Tacoma is very frequently relating to this issue. Several solutions are available to you according to the level of play you have with your lock. The first is that in some cases the offset is minimal and a simple greasing of the system with thick grease is enough to eliminate the problem. Secondly, it is also conceivable that you really have a lot of play on your lock and that each time the trunk “jumps”, in which case you would have to strip off the cover that allows access to the lock (inside the trunk). Then, using torx screws, you unscrew the striker attached to the threshold, simply push it back a little towards the inside of the trunk and tighten it again. Make sure to examine the centering of the striker in relation to the trunk lock. If after examining the trunk of your Toyota Tacoma closes badly, it means that you have moved it too far, repeat the process by pushing the striker less.
Noise in my trunk Toyota Tacoma : Rivet following plate swap in the trunk/ bumper
Finally, one of the last possibilities. It is that following a license plate swap you were unlucky and that a piece of rivet fell backside your plate. Indeed, when a plate replacement is made, to remove the old one the procedure used is to drill the existing rivets to be able to put out the license plate. Unfortunately, it can happen that part of the rivet falls into the hole of the bumper and it will therefore wander inside the bumper and can trigger an annoying noise. To check that it is this problem you are experiencing, and that you have a trunk noise on your Toyota Tacoma linked to a rivet, you will need to examine that it is in the tailgate open it and stir it to specify the noise. If this is your situation, you will have to remove the linings from the trunk to remove it. Finally, if it is your bumper, it is in this rarer and more embarrassing situation, you will have to remove the bumper to remove the bits of rivet that are running around.
